hotelsilikon.blogg.se - How to install navit on raspberry pi

#HOW TO INSTALL NAVIT ON RASPBERRY PI SERIAL#
#HOW TO INSTALL NAVIT ON RASPBERRY PI UPDATE#

Where the reception in the house tends to be good, you can test with your phone. Make sure that the reception to the GPS satellites can be made, so go outside, or at least to a window. Again, we have to specify the baud rate sudo gpsd /dev/ttyAMA0 -F /var/run/gpsd.sock -n The list is a bit confusing, but it works well if only the raw data is needed. Here the baud rate, as well as the device is indicated (with CTRL + A, Q you finish). You start with the first test minicom -b 9600 -o -D /dev/ttyAMA0 Afterwards, we can have the current configuration output: stty -F /dev/ttyAMA0 In this case, no (error) message should occur. In addition, we inform the module that it should work with a baud rate of 9600: stty -F /dev/ttyAMA0 9600 Now everything should be ready and the module ready for the test. If you have not restarted before, this must be done now at the latest sudo reboot now

Sudo apt-get install minicom gpsd gpsd-clients

#HOW TO INSTALL NAVIT ON RASPBERRY PI UPDATE#

Before that, however, we need to update the repositories. We need a few programs to read the Raspberry Pi GPS module. This can also be done after installing the other software. Your file should look like this: dwc_otg.lpm_enable=0 console=tty1 root=/dev/mmcblk0p2 rootfstype=ext4 elevator=deadline rootwaitįor the changes to be accepted, a restart is absolutely necessary. The last entry does not seem to exist in all OS versions by default. As a result, the location of the autostart script might be different depending on your particular. The following entries are deleted: console=ttyAMA0,115200 kgdboc=ttyAMA0,115200 Note: Raspbian is based on the LXDE desktop environment. Then there is the file /boot/cmdline.txt to be edited, sudo nano /boot/cmdline.txt Storing is done with STR + O, finished with CTRL + X. Here the following line (presumably the last one) has to be commented out (or deleted) by means of a rhombus # at the beginning. For this we edit the following file: sudo nano /etc/inittab

#HOW TO INSTALL NAVIT ON RASPBERRY PI SERIAL#

If you have not already released the serial interface before, this must happen beforehand.

The wiring is very simple: GPS Modul Raspberry Pi VCC 3.3V (Pin 1) RX TXD/GPIO 14 (Pin 8) TX RXD/GPIO 15 (Pin 10) GND Ground (Pin 6)

10000mAh Powerbank (alternatively follow this tutorial).

In this tutorial, I’ll show you how tracking works with such a GPS module and what you need for it. Mobility is achieved with a battery pack or a USB power bank. In many outdoor applications, especially those that move (Car-PC, weather balloon, etc.), the exact position is a big advantage. While every smartphone has GPS, the Pi can also be converted into a GPS receiver with a cheap Raspberry Pi GPS module.